adamp
New Member
Posts: 10
|
Post by adamp on Feb 8, 2019 1:13:45 GMT
Just started testing with UI++, using it with sccm to pre-start after pxe. So far I have it prompt for user authentication and do a preflight check. After it closes and then still goes to the sccm dp password prompt and then choose task sequence. Is there a way to bypass the native sccm options and have the selection of which task sequence run from UI++? Haven't seen a example of choosing from multiple task sequences.
|
|
|
Post by easyrimka on Feb 9, 2019 19:54:09 GMT
you didnt read anything, this part is covered by the PDF. This is what i was using: launching ui++ during prestart, setting the Ts i want the user to choose in the menu, then starting OSD, without any SCCM menu.
|
|
adamp
New Member
Posts: 10
|
Post by adamp on Feb 11, 2019 16:12:17 GMT
Got the TS selection working with a choiceinput, thanks.
|
|
|
Post by ryandengstrom on Feb 26, 2019 21:51:42 GMT
you didnt read anything, this part is covered by the PDF. This is what i was using: launching ui++ during prestart, setting the Ts i want the user to choose in the menu, then starting OSD, without any SCCM menu. I am fairly new to UI++, and I am also unable to locate where this is discussed in the pdf. Please share the page number this is on for reference. Thanks!
|
|
|
Post by Jason on Feb 26, 2019 22:20:01 GMT
Section 6.1.3 in the documentation briefly discusses this but doesn't go into great detail.
|
|